Editorial

CG FLOORING SYSTEMS COMPLETES MAJOR FAST-TRACK FLOOR UPGRADE

Baxi Group PremisesCG Flooring Systems (CGFS) has successfully completed its biggest and most demanding project Following removal of the foundry equipment a detailed floor survey revealed several major challenges, including seven large pits up to 3 metres deep, a number of vertical steel columns, horizontal I-beams and steel bolts within the floor, damaged expansion joints, and low and high areas spread throughout the building.

All columns, beams and bolts were removed, and around 150 linear metres of expansion joints were repaired. The seven pits, totalling nearly 500m? in surface area, were filled with consolidated hardcore, and then covered with a waterproof  membrane and mesh reinforcement. The edges of the pits were cut to provide clean, vertical surfaces, and then approximately 1000 600mm long dowel bars were inserted in the walls to provide a load transfer mechanism to support the new floor. Nearly 100m? of concrete were poured in five hours to bring the pits up to floor level.

Elsewhere in the building a base screed was used to build low areas up to floor level, while high areas were scabbled to lower them. The entire floor area was then   shot-blasted to provide a positive key for the wearing surface.

The wearing surface selected by CGFS consisted of a nominal 10mm-thick pumped cementitious screed and was completed in five days.  Once this had cured, all existing floor joints were transferred through and sealed with a  specialised filler in order to reduce the potential for cracking caused by substrate movement.  Finally, a clear acrylic seal was applied to the entire surface.

CG Flooring Systems Ltd,

Web: www.cg-flooring.com
        
Tel: 01484 600085   Fax: 01484 600095

E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
 
Pin It